TurboGuard® Pre-Filters, designed for optimal filtration in high-flow environments, features a unique inside-out flow configuration. The one-piece extruded outer cage ensures no media migration, simplifying maintenance and removal. With one-piece molded end caps and a Quad Seal gasket system, secure handling during installation and removal is guaranteed. These filters boast the highest dirt-holding capacity, approximately 25 lbs (11.5 Kg) before removal is required. Operating at a low-pressure drop (less than 0.2 bar at specified flow rates), TurboGuard® Pre-Filters offer efficient and reliable performance. Ideal for pre-filtering applications in Deep Bed demineralizers, RO membrane protection, and retrofitting OEM high-flow filter housings.
Key Features
- Flow is from the inside core to the outer pleats.
- TurboGuard Filters are wrapped in a one-piece extruded outer cage, preventing media migration during inside-out flow
- TurboGuard’s one-piece extruded outer cage allows for easier maintenance and removal after use
- One-piece molded end caps, including molded-in bail for secure handling during installation and removal
- Quad Seal gasket system to provide maximum sealing surfaces
- Highest dirt holding capacity - approximately 25 lbs (11.5 Kg) before removal is required
- Low-pressure drop - less than 0.2 bar in service at a specified flow rate
- Optimized media surface area allows full use of installed media area - not blocked off by media “squeezing”
Typical Applications
- Pre-filter for protection of Deep Bed demineralizers
- Pre-filter for protection of RO membranes
- Retrofit OEM high-flow large geometry filter housings
.svg)
.svg)
